Research Methods of Foam Phosphogypsum Blocks Based on Phosphorus Fertilizer Waste

Authors

  • Zafar Sattorov Tashkent Institute of Architecture and Civil Engineering image/svg+xml
  • Vaxidjon Mamatov Tashkent Institute of Architecture and Civil Engineering image/svg+xml

DOI:

https://doi.org/10.5281/zenodo.7791684

Keywords:

concrete, plaster, walling of a product, manufacture, ashes, phosphogypsum foam, building materials, additive, mineral knitting, phosphogypsum, phosphorite, raw material, properties, cement, energy saving, factor a mitigation

Abstract

The materials needed for the production of foam phosphogypsum consist of gypsum, phosphogypsum waste, water, foaming agent. These materials must meet standards for use. Today, several methods of foam phosphogypsum production are common.

Let's kill. In this method, first gypsum paste or phosphogypsum waste is prepared, then special foam prepared in a foam generator is added to it. The mixture in the concrete mixer is mixed with foam and a mixture of foam concrete is obtained, which later hardens to form foam phosphogypsum. This method can be called the most used and reliable. For this method, organic foaming agents, a mixture with improved components and special foam generators are usually used.

Dry mineralization. In this method, a foam phosphogypsum mixture is obtained from a generator by combining low-performance foam with dry components. At the same time, a stable foam phosphogypsum mixture with a small amount of free water is formed. Small particles of the solid phase settle on the surface of foam bubbles. This method is used in continuous foam concrete production technology. For this method, SDO foam generator, foam foam generator and special mixers are used.

Barotechnology. With this method, foam phosphogypsum is obtained under excess pressure of all raw material components. First, water with a foaming agent is poured into the stabilizer, then all additives are added. After that, the air is sent to the air mixer with a compressor and the internal pressure is created. Foam phosphogypsum mixture is produced in a foam mixer, sent under pressure from the mixer to the mold or monolithic construction. For this method, synthetic foaming agents and stabilizers are used.

Downloads

Download data is not yet available.
References

Downloads

Published

01-04-2023

Issue

Section

Articles

Categories

How to Cite

[1]
Z. Sattorov and V. Mamatov, “Research Methods of Foam Phosphogypsum Blocks Based on Phosphorus Fertilizer Waste”, JCET, vol. 1, no. 1, pp. 1–11, Apr. 2023, doi: 10.5281/zenodo.7791684.

Share

Most read articles by the same author(s)

Similar Articles

11-20 of 29

You may also start an advanced similarity search for this article.