Investigation of Thermohydrodynamic Processes in the Solar Air Heater Absorber of a Polygeneration Device Intended for Freshwater and Hot Water Production

Authors

  • Bekzod Abdukarimov Fergana State Technical University Fergana

DOI:

https://doi.org/10.24412/2181-4473-2025.3.201

Keywords:

solar air heater, polygeneration system, heat transfer, pressure, density of the flow, absorber, boundary condition, energy loses.

Abstract

In this  article presents the mathematical modeling and numerical analysis of heat and mass transfer processes in solar air heater collectors with complex absorbers, with particular attention to the role of embedded tube air channels and cavity depth geometry. Solar energy–based desalination and hot water production technologies are highlighted as sustainable and environmentally friendly solutions to the global freshwater shortage. A theoretical framework was developed based on the laminar boundary layer differential equations, accounting for thermodynamic and hydrodynamic properties of compressible media, as well as pressure variations and frictional forces in heat transfer. The influence of geometric cavities on airflow structure was studied, demonstrating that indentation-induced vortices enhance turbulence near the wall, intensify temperature gradients, and significantly increase convective heat transfer. However, excessive cavity depth leads to additional turbulence and higher pressure losses, thereby reducing efficiency. Semi-empirical approaches derived from the hypotheses of Prandtl, Taylor, and Kolmogorov were applied to optimize boundary layer modeling, introducing the cavity coefficient (φ) as a governing parameter. Experimental and theoretical results confirm that properly optimized cavity geometries not only stabilize the airflow but also maximize thermohydraulic efficiency of solar collectors. Validation of the proposed mathematical model was carried out using COMSOL Multiphysics 6.0, with an average relative error of 4.6%, confirming the adequacy of the model. The findings provide a reliable foundation for the design and optimization of advanced solar air heater collectors integrated into polygeneration systems, contributing to sustainable water desalination, hot water supply, and improved energy efficiency under varying climatic conditions.

Downloads

Download data is not yet available.
References

Downloads

Published

29-09-2025

Issue

Section

Articles

Categories

How to Cite

[1]
B. Abdukarimov, “Investigation of Thermohydrodynamic Processes in the Solar Air Heater Absorber of a Polygeneration Device Intended for Freshwater and Hot Water Production”, JCET, vol. 3, no. 2, pp. 1–7, Sep. 2025, doi: 10.24412/2181-4473-2025.3.201.

Share

Most read articles by the same author(s)

Similar Articles

11-20 of 37

You may also start an advanced similarity search for this article.